Andreoffringa

RFI and radio astronomy

Radio-Frequency Interference and Radio Astronomy

Cutting-edge radio observatories such as the Jansky Very Large Array (VLA) in New Mexico, the Low-Frequency Array (LOFAR) in the Netherlands, and the Murchison Widefield Array (MWA) in Australia are extraordinarily sensitive instruments that survey the sky with remarkable depth and resolution. Over recent decades the bandwidth these telescopes observe has grown dramatically, and it frequently overlaps with portions of the radio spectrum that were never set aside for astronomy. At the same time, rapid technological progress is making the spectrum ever more crowded. As a result, radio observations are disturbed by human-made transmitters whose signals can be many orders of magnitude stronger than the faint celestial emission astronomers are trying to detect. This disturbance is known as radio-frequency interference, or RFI.

How RFI Overwhelms Astronomical Signals

When the observed frequency band contains RFI and therefore coincides with frequencies used by other transmitting devices, the recorded data become corrupted and cannot be used as-is. Because interference may be far stronger than the signal of interest, calibrating contaminated data can become impossible. The sheer difference in strength means the astronomical signal is buried beneath the interference and cannot be extracted.

The Growth of Electromagnetic Devices

Around 1980, as technical advances filled the radio spectrum ever more densely (V. Pankonin and R. M. Price, 1981), observers began noticing interference produced by electronic equipment (Thompson, Gergely & Vanden Bout, 1991) and started devising ways to counteract it. The earliest approaches were carried out by the scientist reducing the data and relied on manually selecting clean data — for instance, discarding data from specific antennas, or from particular time and frequency ranges where interference was received. Though laborious, these methods proved adequate in most situations over the past few decades. Siting telescopes in radio-quiet locations would help, but that is not always practical.

Radio Astronomy Moves Forward

With next-generation radio telescopes now entering service, the era of software-driven instruments producing terabyte-scale data sets has arrived. Data reduction in radio astronomy is therefore entering a new phase that places greater emphasis on automated processing and on pipelining the individual steps of reduction. Handling RFI is a crucial part of that process. As data volumes and required sensitivity rise sharply, and as growing use of electronic equipment increases RFI contamination, the next generation of telescopes demands more advanced automated flagging procedures. The RFI mitigation page explains a range of techniques for dealing with interference.

AOFlagger software interface used for automated RFI detection and flagging
Automated flagging with AOFlagger
LOFAR high-band antenna array with a person standing beside it
A LOFAR high-band antenna

RFI Mitigation Techniques

References

  • V. Pankonin and R. M. Price (1981): "Radio Astronomy and Spectrum Management: The Impact of WARC79". IEEE Trans. on Electromagnetic Compatibility, EMC-23:308–317.
  • A. R. Thompson, T. E. Gergely, and P. A. Vanden Bout (1991): "Interference and Radioastronomy". Physics Today, 44:41–49.

Explore More

User Login

Username *
Enter your account username to sign in.
Password *
Enter your account password to sign in.

Request New Password

Powered by Drupal